Hardware Store Shelving

Gondola Shelving For Hardware Stores

Wall Store Shelving

A Wall Section of Steel Shelving includes one Basic Upright with Cap, one Base Shelf, one Kickplate, one Back Panel and one Top, Center, and Lower Spanner. If the Gondola is 78" tall or taller, the section would also include one Splicer Spanner.

Gondola Store Shelves

A Gondola Section of wall shelves includes one Basic Upright with Cap, two Base Shelves, two Kickplates, two Back Panels and one Top, Center, and Lower Spanner. If the Gondola is 78" tall or taller, the section would also include one Splicer Spanner for two piece backs.

Gondola Shelves

Available in 3' and 4' widths, 8" to 30" depths, two and 3 position in either a flat position, 15 degree or 30 degree down slope.

Gondola End Cap

Gondola Shelving Hardware Store Shelving end cap is best configured from a single sided gondola section that slides up and sits flush against and existing Gondola Double Sided aisle.

Shelf Fences & Dividers

Shelf fencing and dividers is an affordable solution for binning of lets say light weight plastic pipe fittings, small electronics, and most any hardware merchandise less than 3 inches.  Gondola shelves can be set at a 15 degree down slope with fences and dividers can provide better visibility for boxed goods.